ArduIMU+ V3 kit

Important Note: ArduIMU is not an Autopilot. It's just an orientation solution (the heart of an Autopilot) and can be used on anything where you want to know its orientation in respect to the ground--boats, cars, rockets or even your dog. To learn more about IMUs read here.

MPU-6000 uses SPI for max performance.


  • Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
  • Tri-Axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g
  • Reduced settling effects and sensor drift by elimination of board-level cross-axis alignment errors between accelerometers and gyroscopes
  • Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection with supported software (not yet currently supported in DIY Drones code)
  • Full Chip Idle Mode Supply Current: 5µA
  • On-chip timing generator with ±1% frequency variation over full temperature range
  • User self test
  • 10,000g shock tolerant


  • Pin compatible with ArduIMU V2.
  • Breadboard compatible (ArduIMU V2 was not!).
  • Smaller size (1.5" x 1.0").
  • Atmega CPU has more % available for other tasks.
  • The 6 analog pins are now available!
  • Arduino compatible and open source.
  • 3 status LED's (RGB).
  • I2C port with 3.3V translation.
  • GPS port with FTDI autoswitch.
  • This device is suitable for ANY application from rockets to simple movement detection.


Note: This product is not compatible with the u-blox GPS with Compass module.


Live Chat

Available hours: 8am - 5pm PST


Email our team for support

Hardware Services

Find an Authorized Service Center