Adding Ground Control Points (GCPs) with Site Scan Manager

Ground Control Points are used to lock your Site Scan data into the local coordinate system. Without GCPs, the orthomosaic will likely be several feet off. However, Site Scan Manager allows you to reference your orthomosaics with GCPs to bring the accuracy down to an inch or two, allowing you to check the placement of forms before pouring concrete, trenchwork before laying pipe, and beams before fastening down. GCPs also persist throughout a Project so they can be used to check the accuracy of any job or overlay.

To add GCPs, follow the steps below:

  1. Open a Project and navigate to the "Project Data" tab.

    Note: The units of the GCPs correspond to the reference system of the Project. Here, we see Easting and Northing in US Survey Feet because I selected California State Plane Zone 3.



  2. Click "New GCP", enter the Name, X (typically Easting or Longitude), and Y (typically Northing or Latitude) and click "Save". Site Scan Manager will then fly to your GCP and and it will appear on the basemap as a triangle.



    Note: GCPs typically come from survey firms in either a table or document like the one below. If you are having trouble deciphering GCPs, contact Success Services at premier.support@3dr.com and we will be happy to help.



  3. After you've finished entering your GCPs, they are all available as a layer in Site Scan Manager and viewable alongside the orthomosaic and CAD files to quickly verify accuracy.

Adding Ground Control Points (GCPs) with Site Scan Manager from 3D Robotics on Vimeo.


Attachments

Live Chat

Available hours: 8am - 5pm PST

Email

Email our team for support

Hardware Services

Find an Authorized Service Center